Allied Telesis AT-S100 - Manual (Page 109)

AT-S100 Management Software User’s Guide
Section I: Command Modes 109
SHOW STATIC-CHANNEL-GROUP
Syntax
show static-channel-group
Parameters
none
Description
Use the SHOW STATIC-CHANNEL-GROUP command to display the
static-channel groups configured on the switch.
For a procedure to set create static port trunks, see “Creating Static
Trunks” on page 49.
Command Mode
Privileged Executive mode
Example
The following example shows the SHOW STATIC-CHANNEL-GROUP
command and a sample of the output:
switch3#show static-channel-group
See Figure 13 for an example display.
Figure 13. SHOW STATIC-CHANNEL-GROUP
Related Commands
“STATIC-CHANNEL-GROUP” on page 184
(switch3)# show static-channel-group
Static Aggregator: sa3
Type: src-dst-mac
Member: ge9
(switch3)#