Allied Telesis AT-S100 - Manual (Page 243)

Section II: Advanced Configuration 243
Chapter 10
Spanning Tree Protocol (STP)
Commands
The commands in this chapter can be used in the Spanning Tree Protocol
(STP) and Rapid Spanning Tree Protocol (RSTP) Protocol daemons. All of
the spanning-tree commands are available in the Configuration Terminal
mode.
This chapter contains the following commands:
ˆ “SHOW SPANNING-TREE” on page 244
ˆ “SPANNING-TREE ENABLE FORWARD” on page 247
ˆ “SPANNING-TREE FORWARD-TIME” on page 249
ˆ “SPANNING-TREE HELLO-TIME” on page 250
ˆ “SPANNING-TREE MAX-AGE” on page 251
ˆ “SPANNING-TREE MODE” on page 252
ˆ “SPANNING-TREE PORTFAST BPDU-FILTER DEFAULT” on
page 253
ˆ “SPANNING-TREE PORTFAST BPDU-GUARD DEFAULT” on
page 254
ˆ “SPANNING-TREE PRIORITY” on page 255
Note
To display the current spanning tree configuration, see “SHOW
SPANNING-TREE” on page 106.