Allied Telesis AT-S100 - Manual (Page 163)

Section I: Command Modes 163
Chapter 5
Interface Configuration Mode
Commands
This chapter provides descriptions of the commands in the Interface
Configuration mode which can access either a port or a vlan interface. For
more information about this mode, see “Interface Configuration Command
Mode” on page 20.
This chapter describes the following commands:
ˆ “CHANNEL-GROUP” on page 165
ˆ “DOT1X PORT-CONTROL” on page 166
ˆ “EXIT” on page 167
ˆ “FLOW CONTROL BACKPRESSURE” on page 168
ˆ “FLOW CONTROL RECEIVE” on page 169
ˆ “FLOW CONTROL SEND” on page 170
ˆ “IP ADDRESS” on page 171
ˆ “IP ADDRESS DHCP” on page 173
ˆ “LACP SYSTEM-PRIORITY” on page 174
ˆ “MDIX” on page 175
ˆ “MIRROR INTERFACE DIRECTION” on page 176
ˆ “MTU” on page 178
ˆ “SHOW RUNNING-CONFIG INTERFACE” on page 179
ˆ “SHUTDOWN” on page 181
ˆ “SPEED” on page 182
ˆ “STATIC-CHANNEL-GROUP” on page 184
ˆ “STORM-CONTROL” on page 185
ˆ “SWITCHPORT ACCESS VLAN” on page 187
ˆ “SWITCHPORT MODE TRUNK” on page 188
ˆ “SWITCHPORT TRUNK ALLOWED VLAN” on page 190
ˆ “TRAFFIC-CLASS-TABLE USER-PRIORITY NUM-TRAFFIC-
CLASSES” on page 192
ˆ “USER-PRIORITY” on page 193