Switchport access vlan – Allied Telesis AT-S100 User Manual
Page 187
AT-S100 Management Software User’s Guide
Section I: Command Modes
187
SWITCHPORT ACCESS VLAN
Syntax
switchport access vlan VLANID <2-4094>
no switchport access vlan VLANID <2-4094>
Parameters
VLANID
Specifies a VLAN ID. Enter a value from 2 to 4094.
Description
Use the SWITCHPORT ACCESS VLAN command to change the default
VLAN for an interface. By default, all ports are assigned to VLAN 1. Use
the no form of this command to remove a previously created VLAN with
the specified VLAN ID.
Caution
Before you enter the SWITCHPORT ACCESS VLAN command, you
must configure a VLAN using the VLAN command.
Note
The default VLAN ID is 1. Do not use a VLAN ID of 1 due to
interoperability issues.
Command Mode
Interface Configuration mode
Example
The following commands set the default VLAN to 3 on port 6:
switch#configure terminal
switch(config)#interface ge6
switch(config-if)#switchport access vlan 3
Related Commands