Set gvrp – Allied Telesis AT-S100 User Manual
Page 212
Chapter 7: GVRP Commands
212
Section II: Advanced Configuration
SET GVRP
Syntax
set gvrp enable|disable
Parameters
enable
Enables GVRP on the switch.
disable
Disables GVRP on the switch.
Description
This command enables or disables GVRP globally on the switch. When
GVRP is enabled, the switch learns GVRP VLANs and GVRP ports
dynamically.
When GVRP is disabled, the switch does not learn any new dynamic
GVRP VLANs or dynamic GVRP ports.
Command Mode
Configuration Terminal mode
Examples
The following commands enable GVRP on the switch:
switch#configure terminal
switch(config)#set gvrp enable
The following commands disable GVRP on the switch:
switch#configure terminal
switch(config)#set gvrp disable
Related Commands
“SET GVRP APPLICANT” on page 213
“SET GVRP DYNAMIC-VLAN-CREATION” on page 214