Enable secret – Allied Telesis AT-S100 User Manual
Page 125
Advertising
AT-S100 Management Software User’s Guide
Section I: Command Modes
125
ENABLE SECRET
Syntax
enable secret (8) LINE
Parameters
8
Specifies a hidden password will follow. This is an optional
parameter.
LINE
Specifies a password for the Privileged Executive Mode. Enter
an alphanumeric value.
Description
Use the ENABLE SECRET command to assign a privileged-level
password, or secret. By default, there is no secret assigned. For
information about the Privileged Executive mode commands, see
“Privileged Executive Command Mode” on page 18.
Command Mode
Configuration Terminal mode
Example
The following command assigns “aloha5551212” as the hidden password:
switch#configure terminal
switch(config)#enable secret 8 aloha5551212
Related Commands
Advertising