HID DTC4500 User Guide - Manual (Page 111)

© 2011 HID Global Corporation All rights reserved
DTC4500 Card Printer/Encoder User Guide L001444 Rev1.1
111
Troubleshooting with the Error Message Table
Error Message Cause Solution
#53
Lam Jam
A card is jammed in the
Lamination module area of the
Printer. Clear the jam according to the
steps in the Troubleshooting
section of the User Guide.
Press QUIT to clear this
message.
#60
Lam Sensor
The Lam Sensor is out of
calibration. Calibrate the Lam Sensor.
# 63
Lam Cart 1 Out
Error
Lam Cart 2 Out
Error
There is no material loaded in
the Laminator Cartridges 1 or
2. Load material into the
Laminator.