Section 5: card lamination module – HID DTC4500 User Guide User Manual
Page 81
©
2011
HID
Global
Corporation
All
rights
reserved
DTC4500 Card Printer/Encoder User Guide L001444 Rev1.1
81
Section 5: Card Lamination Module.
The DTC4500 supports the attachment of an optional Card Lamination Module. This Module can be
ordered pre-installed on the Printer from the factory or can be ordered separately as a field upgradeable
Module.
Once attached, the Card Lamination Module allows you to apply Fargo certified overlaminates for more
secure, tamper-resistant cards. This section explains all aspects of the Card Lamination Module's
operation.
• See
Selecting the Calibrate Laminator tab
for more information on this tab.
• See
for more information on this tab.
IMPORTANT! Fargo Card Printers require highly specialized Print Ribbons to function properly. To
maximize Printer life, reliability, printed card quality and durability, you must use only Fargo Certified
Supplies. For this reason, your Fargo warranty is void, where not prohibited by law, if you use non-Fargo
Certified Supplies. To order additional materials, please contact your authorized reseller.
Danger: The Printer’s Transfer Roller can reach temperatures exceeding 350° F (175° C). Use
extreme caution when operating the Laminator. Never touch the Transfer Roller unless the Printer has
been turned off for at least 20 to 30 minutes.