Safety messages (review carefully) – HID DTC4500 User Guide User Manual

Page 9

Advertising
background image

©

2011

HID

Global

Corporation

All

rights

reserved

DTC4500 Card Printer/Encoder User Guide L001444 Rev1.1

9

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

Danger:

Failure to follow these installation guidelines can result in death
or serious injury.

Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).

• To prevent personal injury, refer to the following safety

messages before performing an operation preceded by this
symbol.

• To prevent personal injury, always remove the power cord prior

to performing repair procedures, unless otherwise specified.

•

To prevent personal injury, make sure only qualified personnel
perform these procedures.

Caution:

This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the left).

• To prevent equipment or media damage, refer to the following

safety messages before performing an operation preceded by this
symbol.

• To prevent equipment or media damage, observe all

established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.

• To prevent equipment or media damage, always wear an

appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).

• To prevent equipment or media damage, always remove the

Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.

•

To prevent equipment or media damage, take jewelry off of
fingers and hands, as well as thoroughly clean hands to remove
oil and debris before working on the Printer.

Advertising