HID DTC4500 User Guide - Manual (Page 52)

© 2011 HID Global Corporation All rights reserved
DTC4500 Card Printer/Encoder User Guide L001444 Rev1.1
52
Selecting the Advanced Settings tab
Setting Option
Write Heat Offset Adjust the Write temperature for the rewriteable cards as
needed.
• Increase the Current Setting to cause more heat to
be used in the printing process of a rewritable card.
OR
• Decrease the Current Setting to cause less heat to be
used in the printing process of a rewritable card.
(Note: Write Heat Offset provides user ability to control
the Printhead heat level when the Write Operation is
performed. Appropriate heat levels should be applied for
the proper writing process.)
Enable Swift ID over USB
connection Enable Swift ID over a USB connection - Check this
item to utilize Swift ID via a USB connection. When this
box is checked the Ethernet connection (if applicable) on
the printer will not be operational.
• If the USB selection is not be accessible, the HID EEM
driver that Swift ID uses to connect via a USB
connection has not been installed.
• This driver can be found on the installation CD or it can
be down loaded from the HID Global support page.
• The easiest method for enabling Swift ID is to un-
install the printer driver and its components and go
through the installation procedure.
Select the desired connection type for the Swift ID
application: USB or ETHERNET.