Section 9: cleaning, Safety messages (review carefully) – HID DTC4500 User Guide User Manual

Page 116

Advertising
background image

©

2011

HID

Global

Corporation

All

rights

reserved

DTC4500 Card Printer/Encoder User Guide L001444 Rev1.1

116

Section 9: Cleaning

The Card Printer is built to require a minimum amount of maintenance. Nevertheless, there are a few
procedures you can perform on a regular basis or as needed to ensure the best possible performance

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

Danger:

Failure to follow these installation guidelines can result in
death or serious injury.

Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).

• To prevent personal injury, refer to the following safety

messages before performing an operation preceded by this
symbol.

• To prevent personal injury, always remove the power

cord prior to performing repair procedures, unless otherwise
specified.

•

To prevent personal injury, make sure only qualified
personnel perform these procedures.

Caution:

This device is electrostatically sensitive. It may be
damaged if exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).

• To prevent equipment or media damage, refer to the

following safety messages before performing an operation
preceded by this symbol.

• To prevent equipment or media damage, observe all

established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.

• To prevent equipment or media damage, always wear an

appropriate personal grounding device (e.g., a high quality
wrist strap grounded to avoid potential damage).

• To prevent equipment or media damage, always remove

the Ribbon and Cards from the Printer before making any
repairs, unless otherwise specified.

•

To prevent equipment or media damage, take jewelry off
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.

Advertising