Goulds Pumps 3700 - IOM User Manual
Page 70
Maintenance
If your pump is...
Then...
SX, MX, LA, LX, XLA, or
1.
Loosen and remove the radial-bearing end cover and bearing-
XLX
frame screws.
2.
Remove and discard the radial-bearing end-cover gasket. You will
replace this with a new gasket during reassembly.
3.
Press the radial and thrust deflector out of the radial and thrust end
covers.
If you have an optional radial heat flinger, it replaces the standard
radial deflector and is removed in the same manner except you loosen
three set screws.
119A
Thrust end cover
123
Deflector
228
Bearing frame
360
Radial-bearing end-cover gasket
370P
Bearing-frame screws
SA and MA
Remove the radial-bearing end cover and radial deflector with gasket
or radial deflector from the bearing frame by tapping it out of the frame.
If you have an optional radial heat flinger, it replaces the standard
radial deflector and is removed in the same manner except you loosen
three set screws.
11. Remove any remaining plugs and fittings.
68
Model 3700, API Type OH2 / ISO 13709 1st and 2nd Ed. / API 610 8/9/10/11th Ed. Installation, Operation, and Maintenance
Manual