1 switching one input to one output, 2 switching several inputs to several outputs, Switching one input to one output – Kramer Electronics VS-3232A User Manual

Page 36: Switching several inputs to several outputs, Out 06

Advertising
background image

Operating Your Video Matrix Switcher

31

31

8.4.1 Switching one Input to one Output

To switch one input to one output (in the At Once mode):

1. Press the appropriate digit buttons (for example, 06 representing output 6).

The LCD display shows the following on the right side:

In_ _ =>

Out 06

The left-hand side of the display shows a segment of the input-output
display, automatically shifting the content to show the 06 output.

2. Press the appropriate input number (for example, 27 representing input 27):

 When in the At Once mode, the switching takes place immediately and

the LCD display shows a segment of the input-output status, including
the switched input and output (for example 06-27)

When in the Confirm mode, the LCD display shows the following:

In 27 =>

Out 06

 Press the blinking TAKE button to switch the input to the output

8.4.2 Switching Several Inputs to Several Outputs

In the At Once mode, the VS-3232A will execute each OUT-IN combination
separately (see

Section 8.4.1

). If you want to switch several inputs to several

outputs simultaneously, it is necessary to operate the machine in the Confirm
mode.

In the Confirm mode you can key-in several actions and then confirm them by
pressing the TAKE button once (simultaneously switching several inputs to
several outputs).

To simultaneously switch several inputs to several outputs in the Confirm
mode (the TAKE LED is illuminated), do the following:

1. Press the appropriate digit buttons for an out-in combination.

The TAKE button blinks.
Key-in additional output-input combinations.
The LCD display can show up to five keyed-in actions, as follows

1

:

09 =>

06 05 => 07

2. After completing the output-input switching sequence, press the blinking

TAKE button to carry out the switching operation.
The inputs switch to the respective outputs, as shown on the LCD display
and the TAKE LED no longer blinks and remains illuminated.


1 In this example, input 9 is set to switch to output 06 and input 5 is set to switch to output 7

Advertising