Kramer Electronics VS-3232A - Manual (Page 43)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your Video Matrix Switcher
38
6. When selecting 1 (Left), the following appears on the LCD display:
Input 11
0.0dB <= = -1.5dB
When selecting 2 (Both L&R), the following appears on the LCD display
Input 11
0.0dB <= = = = > -1.5dB
When selecting 3 (Right), the following appears on the LCD display
Input 11
0.0dB = = > -1.5dB
7. Use the LEVEL UP and LEVEL DOWN buttons to adjust the volume level.
The volume level changes by one step with each push of the button.
Push and hold the buttons to increase / decrease the volume continuously.
When adjusting the volume, you can change the Left, Both (L&R) and
Right assignment by pressing the corresponding button 1, 2 or 3. For
example, you can decrease the Left level by -0.5 dB, then raise Both levels
by +2 dB, and then raise the Right level by +1 dB. This way you can adjust
the volume as well as the stereo balance.
8. Press the ENT or ESC button to complete the level adjustment:
 Press the ENT button to store the audio level values in non-volatile
memory. The LCD displays the following:
Input 11
-1.0dB VOLUME SET -1.5dB
 Press the ESC button to disregard changes, and load the channels with
the last stored values. The LCD displays the following:
Input 11
-1.5dB Restore initial value -1.5dB
When adjusting the volume, you can monitor the audio level changes by using
any audio measuring equipment. The audio level changes will be implemented
only after pressing the ENT button. Pressing ESC will return the audio values
to their previous settings.
9. Upon completion of the adjustment, the LCD displays the following:
Continue Volume Setup?
YES - ENT ESC - NO
If you want to adjust other input or output channels, press ENT.
Do the same to adjust any of the output levels (from 0dB to -100dB).