Kramer Electronics VS-3232A - Manual (Page 39)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your Video Matrix Switcher
34
8.5.2 Recalling Setups
To recall a setting, do the following:
1. Press the MENU button once.
The Menu buttons
1
illuminate and are enabled.
2. Press the illuminated RCL button.
The LCD display shows the message:
RECALL <= __
3. Insert the appropriate digits from 01 to 59
1
(for example, press 1 twice
for 11).
The LCD display shows the recalled setup.
When in the CONFIRM mode (the TAKE button is illuminated), repeat the
steps above and then press the TAKE button to confirm the action.
After recalling a setup in the CONFIRM mode, while the TAKE button is
blinking, you can review the content of the recalled setup using the  or the
 buttons.
If the recalled setup is not the desired one, you can recall another setup by
entering a different setup number, thus letting you review as many setups as
needed before implementing the required setup.
When trying to recall an empty setup
2
, the LCD display shows the message:
Setup Empty
another ## ?
followed by the message
3
:
RECALL <= __
8.6 Using the DEFAULT SETUP Button (Unity Setting)
You can select a configuration that is used often and store it as the default
setup (or the UNITY setting), which can be easily recalled by pressing the
DEFAULT SETUP button. You can store the default setup via the menu
commands and then recall it with the touch of a button.
The default setup stores a setup, which is defined via the DEFAULT SETUP
configuration menu, and includes the switcher configuration, volume levels
for each input and output, and the cross-points status.
1 When trying to recall a setup beyond 59, the LCD display shows the following message: No more than 59
2 That is, a setup # for which no setup is actually stored
3 The same as in step 2 above