Kramer Electronics VS-3232A - Manual (Page 49)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
The MENU Commands
44
9.9 Selecting the TOTAL RESET Option
The TOTAL RESET options require you to press the blinking TAKE button
twice for double confirmation.
Table 15 summarizes the TOTAL RESET
menu options:
Table 15: Total Reset Menu
Press: To select: After the change, the LCD displays:
1 All outputs OFF, to
disconnect all the outputs
MATRIX erased – all outputs set to OFF
2 Factory default, to the
factory default state
• OUT 1 is connected to IN 1, OUT 2 is connected to IN
2 … OUT 31 is connected to IN 31 and OUT 32 is
connected to IN 32
In both cases (above), the system status and the volume control stages are set
as follows:
• The gain level of all the input and output channels is set to 0dB
• The audio switching method is set to fade out-in (clean switching)
• The SYNC configuration is set to GENLOCK OFF- immediate switching
• All the interfaces are set to ON
• The interface Reply is set to Reply
• The interface protocol is set to Hex Kramer 2000
• The default setup is set to the Factory default