Konica Minolta bizhub 420 - Manual (Page 126)

Transmission Applications 7
bizhub 500/420 7-5
Tr
ansmission
Ap
plicat
ion
s
Chapter 7
*1
: This can be used to transmit to receiving stations with closed area com-
munication mode selected.
It is impossible to communicate with a FAX without F-code function.
*2
: F-code is used.
!
Detail
The key representing the function you select will be appear reversed.
Press [Cancel] to return to the FAX screen.
V.34 is a communication mode used by the Super G3 FAX.
Password TX
*1
: Transmission can be sent with a password attached, as re-
quired when the receiving station is using a closed area com-
munication mode. (page 7-26)
Polling TX: This function allows you to read a document and store it in
memory until the destination initiates transmission by sending
a command to receive (polling). (page 9-2)
Polling RX: This function allows you to initiate reception by sending a com-
mand to a destination to receive a document that is set for
transmission at the destination. (page 9-5)
Timer TX: The time to start communication can be specified. (page 3-38)
F-Code TX
*2
: This is a function in which the SUB Address and the password
are specified to use the Confidential Communication and the
Relay Request. (page 7-28, page 7-31)
Line Setting Overseas TX A lower baud rate will be employed. (page 3-40)
ECM OFF Error Correction Mode (ECM) can be disabled. (page 7-34)
V.34 OFF When the V.34 protocol can not be used due to restrictions of
exchange equipment, the V.34 mode is disabled for transmis-
sion. (page 7-36)