Konica Minolta bizhub 420 - Manual (Page 26)

Introduction 1
bizhub 500/420 1-17
In
tr
od
uc
ti
on
Chapter 1
1.5 Descriptions and Symbols for Documents and Paper
The use of words and symbols in this manual are explained below.
1.5.1 “Width” and “Length”
Whenever paper dimensions are mentioned in this manual, the first value al-
ways refers to the width of the paper (shown as “Y” in the illustration) and the
second to the length (shown as “X”).
1.5.2 Paper Orientation
Lengthwise (w)
If the width (Y) of the paper is shorter than the length (X), the paper has a ver-
tical or portrait orientation, indicated by w.
Crosswise (v)
If the width (Y) of the paper is longer than the length (X), the paper has a hor-
izontal or landscape orientation, indicated by v.