2 using the control panel to specify settings, 1 network settings, Setting the ip address – Konica Minolta IF-118 User Manual
Page 35: Using the control panel to specify settings -8, Network settings -8 setting the ip address -8
3
Getting Ready
3-8
IF-118
3.2.2
Using the Control Panel To Specify Settings
3.2.2.1 Network Settings
These settings can be specified from the “NETWORK SETTINGS” menu
in Utility mode.
This section describes how to specify settings for the following functions.
G
IP ADDRESS
G
SUBNET MASK
G
GATEWAY
G
DNS CONFIG.
G
GATEWAY TX
✎
Note
Be sure to consult your network administrator before specifying any of
the network settings.
✎
Tip
If you wish to cancel a change to a network setting before applying it,
press the [NO] key. Press the [YES] key after the message “STOP
SETTING?” appears.
Setting the IP Address
1
Press the [UTILITY] key.
The Utility mode menu appears.
2
Press the
or
key until
“NETWORK SETTING” appears.
3
Press the [1] key on the 10-key pad
to select “IP ADDRESS”.