Konica Minolta IF-118 - Manual (Page 50)

Getting Ready 3
IF-118 3-23
3.2.3 Specifying Settings Using PageScope Light
The network settings can be specified using PageScope Light.
1 Start up PageScope Light.
❍ Refer to “Using PageScope Light” on page 2-14.
2 Log in to the Administrator mode.
3 To specify the settings using PageScope Light, click the appropriate
tab and specify the desired settings, and then click the [Apply] button.
❍ If the settings on the “Network” tab are modified, they are only
enabled after the [Apply] button is clicked, then the [Reset] button
next to “NIC and Printer Controller Reset” on the “System” tab is
clicked after the message “Update Successful” has appeared.
3.2.3.1 “Network” tab
TCP/IP Configuration
TCP/IP Configuration
Function Description
IP Address This function is used to specify the IP address for the copier.
Subnet Mask This function is used to specify the subnet mask used to access
the network.
Default Gateway This function is used to specify the default gateway used to
access the network.
Base Port Number This function is used to specify the port number for RAW
printing.