Konica Minolta IF-118 - Manual (Page 105)

6 Using Internet Faxing Operations
6-6 IF-118
❍ The following halftone settings are available.
STD: Standard
FINE: Fine
S/F: Superfine
6.1.4 Changing the Transmission Mode Settings
When entering the destination with the 10-key pad, you can change the
transmission mode settings from the screen for entering the e-mail
address. If the settings are not changed, the document is sent using the
default settings. (Refer to “Specifying the E-mail Mode Settings” on
page 3-16.)
1 Press the key in the screen for
entering the e-mail address.
2 Press the and keys to select
“BASIC” or “ADVANCED”, and then
press the [YES] key.
❍ If “ADVANCED” is selected, the screen for specifying the
maximum document size for transmission appears. (Go to step 3.)
❍ If “BASIC” is selected, the screen for entering the e-mail address
appears.
3 Press the and keys to select
the maximum transmission size
(metric models: “A4”, “B4”, or “A3”;
inch models: “LT” or “11
× 17”).
4 To continue changing other settings, press the key. (Go to step 5.)
❍ If the [YES] key is pressed, the transmission settings screen
closes, and the screen for entering the e-mail address appears.
❍ If the [START] key is pressed, the transmission settings screen
closes, and the copier starts to scan and send the document.
❍ If a broadcast transmission is being performed, a screen asking if
you want to check the destinations appears when the [START] key
is pressed.
❍ If a timer transmission is being performed, after the [START] key is
pressed, the document is scanned, but is not sent until the
specified time.
5 Press the and keys to select
the transmission resolution (“FINE”
or “S/F”).