Konica Minolta IF-118 - Manual (Page 28)

Getting Ready 3
IF-118 3-1
3 Getting Ready
3.1 Connecting to a LAN Network
This copier supports the TCP/IP protocol used by LAN networks. In order
to use this protocol, the copier must be connected to the LAN with a
network cable.
Connecting the LAN Cable
Insert the connector on one end of the LAN cable into the network port
(marked “LAN”) on the left side of the copier, and the connector on the
other end to an open port on a network hub.
✎
Tip
The network port is on the left side of the copier.
Use a Category 5 or 5E LAN cable.
The LAN cable is not included.
About the LEDs
LED1
LED2
LED1 (LINK): This LED lights up when the network cable is connected
correctly. If this LED is not lit, check the connection
again, even if the copier appears to be connected
correctly. If this LED is not lit when both ends are
connected correctly, the network cable may be
damaged.
LED2 (ACT): This LED blinks when data is being transferred.