Brocade Communications Systems Brocade ICX 6650 6650 - Manual (Page 205)

Brocade ICX 6650 Security Configuration Guide 185
53-1002601-01
Displaying 802.1X information
To display information about the 802.1X configuration on an individual port, enter the show dot1x
configuration ethernet command.
Syntax: show dot1x config ethernet port
Specify the port variable in stack-unit/slotnum/portnum format.
global-filter-strict-security Whether strict security mode is enabled or disabled globally. Refer to “Disabling
and enabling strict security mode for dynamic filter assignment” on page 171.
quiet-period When the Brocade device is unable to authenticate a Client, the amount of time
the Brocade device waits before trying again (default 60 seconds).
Refer to
“Setting the quiet period” on page 176 for information on how to change
this setting.
tx-period When a Client does not send back an EAP-response/identity frame, the amount
of time the Brocade device waits before retransmitting the EAP-request/identity
frame to a Client (default 30 seconds).
Refer to
“Setting the wait interval for EAP frame retransmissions” on page 176 for
information on how to change this setting.
supp-timeout When a Client does not respond to an EAP-request frame, the amount of time
before the Brocade device retransmits the frame.
Refer to
“Setting the wait interval for EAP frame retransmissions” on page 177 for
information on how to change this setting.
server-timeout When the Authentication Server does not respond to a message sent from the
Client, the amount of time before the Brocade device retransmits the message.
Refer to
“Specifying a timeout for retransmission of messages to the
authentication server” on page 178 for information on how to change this setting.
maxreq The number of times the Brocade device retransmits an EAP-request/identity
frame if it does not receive an EAP-response/identity frame from a Client (default
2 times).
Refer to
“Setting the maximum number of EAP frame retransmissions” on
page 177 for information on how to change this setting.
re-authperiod How often the device automatically re-authenticates Clients when periodic
re-authentication is enabled (default 3,600 seconds).
Refer to
“Configuring periodic re-authentication” on page 175 for information on
how to change this setting.
Protocol Version The version of the 802.1X protocol in use on the device.
TABLE 32 Output from the show dot1x command (Continued)
Field Description
Brocade# show dot1x configuration ethernet 1/1/3
Port-Control : control-auto
filter strict security : Enable
Action on RADIUS timeout : Treat as a failed authentication
re-authenticate : 150 seconds
PVID State : Normal (101)
Original PVID : 101
PVID mac total : 1
PVID mac authorized : 1
num mac sessions : 1
num mac authorized : 1
Number of Auth filter : 0