Displaying mac addresses in a mac-based vlan – Brocade Communications Systems Brocade ICX 6650 6650 User Manual
Page 246
226
Brocade ICX 6650 Security Configuration Guide
53-1002601-01
Displaying information about MAC-based VLANs
Displaying MAC addresses in a MAC-based VLAN
Enter the show mac-address command to display a list of MAC addresses in a MAC-based VLAN.
NOTE
In this output, (MBV) indicates MAC-based VLAN is enabled.
The following table describes the output from this command.
Type
Dyn Indicates a dynamic host. Sta indicates a static host.
Pri
This field indicates the value set for Foundry-MAC-based VLAN-QoS attribute in the RADIUS
configuration for dynamic hosts, if configured. If the Foundry-MAC-based VLAN-QoS attribute is
not configured, the value will be zero. For static hosts, the user-configured priority value for the
MAC address is displayed.
TABLE 53
Output field description of the show mac-address command
Field
Description
Total active entries
The total number of active entries for all ports.
MAC Address
The MAC addresses assigned to this VLAN.
Port
The interface for which this information is displayed.
Type
Dynamic (MBV) Indicates a dynamic host. Static (MBV) indicates a static host.
Index
The index of the entry in the hardware MAC table.
VLAN
The VLAN to which these addresses are assigned.
TABLE 52
Output field descripion of the show table-mac-vlan ethernet command (Continued)
Field
Description
Brocade# show mac-address
Total active entries from all ports = 1541
MAC-Address Port Type Index VLAN
0000.0020.0001 1/1/3 Dynamic(MBV) 1048 1
0000.0020.0002 1/1/3 Dynamic(MBV) 1832 1
0000.0020.0003 1/1/3 Dynamic(MBV) 9772 1
0000.0020.0004 1/1/3 Static(MBV) 328 1
0000.0020.0005 1/1/3 Dynamic(MBV) 8268 1
0000.0020.0006 1/1/3 Dynamic(MBV) 9084 1
0000.0020.0007 1/1/3 Dynamic(MBV) 632 1
0000.0020.0008 1/1/3 Dynamic(MBV) 3464 1
0000.0020.0009 1/1/3 Dynamic(MBV) 11404 1
0000.0020.000a 1/1/3 Dynamic(MBV) 12220 1
0000.0020.000b 1/1/3 Dynamic(MBV) 3768 1