Brocade Communications Systems Brocade ICX 6650 6650 - Manual (Page 209)

Brocade ICX 6650 Security Configuration Guide 189
53-1002601-01
Displaying 802.1X information
The show run command also indicates the VLAN to which the port has been dynamically assigned.
When you enter the show run command, the output indicates that the port is a member of the
VLAN to which it was dynamically assigned through 802.1X. If you then enter the write memory
command, the VLAN to which the port is currently assigned becomes the port default VLAN in the
device configuration.
If the VLAN name supplied by the RADIUS server corresponds to a statically configured VLAN, the
output indicates that the port is a member of the VLAN to which it was dynamically assigned
through 802.1X. If you then enter the write memory command, the VLAN to which the port is
currently assigned becomes the port default VLAN in the device configuration.
Displaying information about dynamically applied
MAC address filters and IP ACLs
You can display information about currently active user-defined and dynamically applied MAC
address filters and IP ACLs.
Displaying user-defined MAC address filters and IP ACLs
To display the user-defined MAC address filters active on the device, enter the following command.
Brocade# show dot1x mac-address filter
Port 1/1/3 (User defined MAC Address Filter) :
mac filter 1 permit any any
Syntax: show dot1x mac-address-filter
To display the user-defined IP ACLs active on the device, enter the show dot1x ip-ACL command.
Syntax: show dot1x ip-ACL
Displaying dynamically applied MAC address
filters and IP ACLs
To display the dynamically applied MAC address filters active on an interface, enter a command
such as the following.
Brocade# show dot1x ip-ACL
Port 1/1/3 (User defined IP ACLs):
Extended IP access list Port_1/1/3_E_IN
permit udp any any
Extended IP access list Port_1/1/3_E_OUT
permit udp any any