Brocade Communications Systems Brocade ICX 6650 6650 - Manual (Page 67)

Brocade ICX 6650 Security Configuration Guide 47
53-1002601-01
RADIUS security
Enabling SNMP to configure RADIUS
To enable SNMP access to RADIUS MIB objects on the device, enter a command such as the
following.
Brocade(config)# enable snmp config-radius
Syntax: [no] enable snmp config-radius | config-tacac>
The config-radius parameter specifies the RADIUS configuration mode. RADIUS is disabled by
default.
The config-tacacs parameter specifies the TACACS configuration mode. TACACS is disabled by
default.
Identifying the RADIUS server to the Brocade device
To use a RADIUS server to authenticate access to a Brocade device, you must identify the server to
the Brocade device.
Example
Brocade(config)# radius-server host 10.157.22.99
Syntax: radius-server host ip-addr | iipv6-addr | server-name [auth-port number] [acct-port
number]
The host ip-addr | ipv6-addr | server-name parameter is either an IP address or an ASCII text
string.
The auth-port parameter is the Authentication port number. The default is 1645.
The acct-port parameter is the Accounting port number. The default is 1646.
foundry-802.1x-valid-lookup 7 integer Specifies if 802.1x lookup is enabled:
0 - Disabled
1 - Enabled
foundry-MAC-based-VLAN-QOS 8 integer Specifies the priority for MAC-based VLAN QOS:
0 - qos_priority_0
1 - qos_priority_1
2 - qos_priority_2
3 - qos_priority_3
4 - qos_priority_4
5 - qos_priority_5
6 - qos_priority_6
7 - qos_priority_7
TABLE 8 Brocade vendor-specific attributes for RADIUS (Continued)
Attribute name Attribute ID Data type Description