Brocade Communications Systems Brocade ICX 6650 6650 - Manual (Page 210)

190 Brocade ICX 6650 Security Configuration Guide
53-1002601-01
Displaying 802.1X information
Syntax: show dot1x mac-address-filter all | ethernet port
The all keyword displays all dynamically applied MAC address filters active on the device.
Specify the port variable in stack-unit/slotnum/portnum format.
To display the dynamically applied IP ACLs active on an interface, enter a command such as the
following.
Syntax: show dot1x ip-ACL all | ethernet port
The all keyword displays all dynamically applied IP ACLs active on the device.
Specify the port variable in stack-unit/slotnum/portnum format.
Displaying the status of strict security mode
The output of the show dot1x and show dot1x config commands indicate whether strict security
mode is enabled or disabled globally and on an interface.
Displaying the status of strict security mode globally on the device
To display the status of strict security mode globally on the device, enter the show dot1x command.
Brocade# show dot1x mac-address-filter e 1/1/3
Port 1/1/3 MAC Address Filter information:
802.1X Dynamic MAC Address Filter :
mac filter-group 2
Port default MAC Address Filter:
No mac address filter is set
Brocade# show dot1x ip-ACL ethernet 1/1/3
Port 1/1/3 IP ACL information:
802.1X dynamic IP ACL (user defined) in:
ip access-list extended Port_1/1/3_E_IN in
Port default IP ACL in:
No inbound ip access-list is set
802.1X dynamic IP ACL (user defined) out:
ip access-list extended Port_1/1/3_E_OUT out
Port default IP ACL out:
No outbound ip access-list is set