Brocade Communications Systems Brocade ICX 6650 6650 - Manual (Page 217)

Brocade ICX 6650 Security Configuration Guide 197
53-1002601-01
Sample 802.1X configurations
Brocade(config)# interface ethernet 1/2/2
Brocadeconfig-if-e10000-1/2/2)# dot1x port-control auto
Brocade(config-if-e10000-1/2/2)# exit
Brocade(config)# interface ethernet 1/2/3
Brocade(config-if-e10000-1/2/3)# dot1x port-control auto
Brocade(config-if-e10000-1/2/3)# exit
Hub configuration
Figure 7 illustrates a configuration where three 802.1X-enabled Clients are connected to a hub,
which is connected to a port on the Brocade device. The configuration is similar to that in Figure 6 ,
except that 802.1X port security is enabled on only one port, and the multiple-hosts command is
used to allow multiple Clients on the port.
FIGURE 7 Sample 802.1X configuration using a hub
Sample 802.1x configuration using a hub
The following commands configure the Brocade device in Figure 7
Brocade(config)# aaa authentication dot1x default radius
Brocade(config)# radius-server host 192.168.9.22 auth-port 1812 acct-port 1813
default key mirabeau dot1x
Brocade(config)# dot1x-enable ethernet 1/2/1
Brocade(config-dot1x)# re-authentication
Brocade(config-dot1x)# timeout re-authperiod 2000
Brocade(config-dot1x)# timeout quiet-period 30
Brocade(config-dot1x)# timeout tx-period 60
Brocade(config-dot1x)# maxreq 6
Brocade(config-dot1x)# exit
RADIUS Server
(Authentication Server)
Brocade Switch
(Authenticator)
e1/2/1
192.168.9.22
Hub