B&B Electronics Zlinx ZP Series User Manual
Page 41
Manual Documentation Number: ZP24D-250RM-SR-2508
37
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Returned
Value
(Hex)
Association Indication
0x00
Successful Completion - Coordinator successfully started or End Device association
complete
0x01
Active Scan Timeout
0x02
Active Scan found no PANs
0x03
Active Scan found PAN, but the Coordinator Allow Association bit is not set
0x04
Active Scan found PAN, but Coordinator and End Device are not configured to support
beacons
0x05
Active Scan found PAN, but Coordinator ID (PAN ID) value does not match the ID of the End
Device
0x06
Active Scan found PAN, but Coordinator CH (Channel) value does not match the CH of the
End Device
0x07
Energy Scan Timeout
0x08
Coordinator start request failed
0x09
Coordinator could not start due to Invalid Parameter
0x0A
Coordinator Realignment is in progress
0x0B
Association Request not sent
0x0C
Association Request timed out - no reply was received
0x0D
Association Request had an Invalid Parameter
0x0E
Association Request Channel Access Failure - Request was not transmitted - CCA failure
0x0F
Remote Coordinator did not send an ACK after Association Request was sent
0x10
Remote Coordinator did not reply to the Association Request, but an ACK was received _
after sending the request
0x11
[reserved]
0x12
Sync-Loss - Lost synchronization with a Beaconing Coordinator
0x13
Disassociated - No longer associated to Coordinator
AP (API Enable) Command
<Serial Interfacing> The AP command is
used to
enable the RF module to operate using a
framebased
API instead of using the default
Transparent
(UART) mode.
Refer to the API Operation section when API operation is enabled
(AP = 1 or 2).
AT Command: ATAP
Parameter Range:0 - 2
Parameter Configuration
0
Disabled (Transparent
operation)
1 API
enabled
2
API enabled (with
escaped characters)
Default Parameter Value:0
Minimum Firmware Version Required:
v1.x80