Hale SMR User Manual
Page 12
Safety Precautions
1-2
Stainless Max Series Pumps
WARNING !
THE SM SERIES PUMP AND GEARBOX ARE HEAVY AND BULKY, WEIGH-
ING UP TO 750 TO 850 LBS. / 340 TO 386KGS (APPROXIMATE). BE CER-
TAIN TO USE PROPER LIFTING SUPPORT DEVICES CAPABLE OF HAN-
DLING THE LOAD WHEN REMOVING OR INSTALLING SM SERIES PUMP
AND GEARBOX ASSEMBLIES.
❑
Installation should be performed by a trained and qualified
installer, or your authorized Hale Products service representative.
Be sure the installer has sufficient knowledge, experience and the
proper tools before attempting any installation.
❑
The installer is responsible for observing all instructions and
safety precautions in his or her daily routine as dictated by
regional safety ordinances or departmental procedures.
❑
DO NOT permanently remove or alter any guard or insulating
devices, or attempt to operate the system when these guards are
removed.
Make sure all access /service panels and covers are installed,
closed and latched tight, where applicable.
❑
DO NOT remove or alter any hydraulic or pneumatic connections,
electrical devices, etc. DO NOT tamper with or disconnect safety
features or modify protective guards (such as covers, or doors).
DO NOT add or remove structural parts. Doing so voids the
Stainless Max warranty.
Any of the above could effect system capacity and/or safe
operation of the system and is a serious safety violation which
could cause personal injury, could weaken the construction of the
system or could affect safe operation of the Stainless Max Pump.
WARNING!
NO MODIFICATIONS OR ADDITIONS MAY BE MADE TO THE STAIN-
LESS MAX PUMP SYSTEM WITHOUT PRIOR WRITTEN PERMISSION
FROM:
Hale Products, Incorporated
Fire Suppression Equipment Group
700 Spring Mill Avenue
Conshohocken, PA 19428
Telephone: ....610-825-6300
Fax: ............... 610-825-6440