Hale SMR - Manual (Page 99)

Stainless Max Series Pumps 6-21
Maintenance and Repair
Rear Oil Seal
See Figure 6-11: “Rear Oil Seal Breakdown, Pedestal.”
If the pedestal is installed to a gearbox or other apparatus, dis-
mantle the attached apparatus from the pedestal before servicing its
internal components.
For gearbox instructions, see separate sections later in this manual.
For attached apparatus, see separate manual provided by appara-
tus manufacturer.
The rear oil seal is located at the tail end of the pedestal assembly,
within the rear seal housing.
Removal
1. First, review preceding section “Before You Begin...,” begin-
ning on page 6-1.
2. Drain oil into an appropriate container from the pedestal and/
or gearbox. See Figure 6-1: “Recommended Lubricants” on
page 6-2, for oil capacities.
Figure 6-11: Rear Oil Seal Breakdown, Pedestal
Rear Oil Seal
Nut, Pump
Shaft
Lock Washers
(pair)
Pump (Impeller)
Shaft
Seal Housing and
Gasket
Wear Ring
Bearing
Drive Flange
Rear Seal
Housing
Gasket, Seal Housing
Tachometer
Option
Wear Ring
Oil Seal
Nut, Pump
Shaft
Lock Washers
(pair)