Hale SMR - Manual (Page 35)

Stainless Max Series Pumps 3-1
Operating Procedures
SECTION
3
: OPERATING PROCEDURES
This section provides information and procedures for the operation of
Hale SM series pumps. Included are post-operation procedures and
procedures for pumping from:
❑ a hydrant
❑ draft
❑ an onboard tank
Unless otherwise indicated, these instructions apply to all Hale SM
series pumps.
NOTICE !
THE PROCEDURES IN THIS SECTION ARE GENERAL OPERATING
PROCEDURES. THEY DO NOT REPLACE THE PROCEDURES AND
POLICIES ESTABLISHED BY YOUR COMPANY, NOR DO THEY REPLACE
THE RECOMMENDATIONS AND PROCEDURES PROVIDED BY THE
APPARATUS MANUFACTURER'S MANUAL.
REFER TO COMPANY PROCEDURES ON SETTING WHEEL CHOCKS AS
WELL AS LAYOUT AND CONNECTION OF HOSES. ALL VALVES, DRAIN
COCKS, AND CAPS SHOULD BE CLOSED.
STATIONARY PUMPING OPERATIONS
Pumping from a Hydrant (General Operation)
1. Position the truck for the best hydrant hookup and discharge
hose layout.
CAUTION!
REFER TO DEPARTMENT PROCEDURES FOR SETTING WHEEL
CHOCKS AND LAYING OUT SUCTION AND DISCHARGE HOSES. ALL
VALVES, DRAIN COCKS, AND CAPS SHOULD BE CLOSED.
2. Bring the truck to a complete stop before attempting to shift from
ROAD to PUMP.
3. Apply the truck parking brake.