7 [source]:power subsystem, Sour, Ubsystem – BNC 835 Programmer Manual User Manual
Page 29: Source]:power subsystem
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.7
[SOURce]:POWer Subsystem
Command
Parameters
Unit
(default)
Remark
[SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]
<value>
dBm
[SOURce]:POWer:MODE
FIXed|LIST|SWEep
FIXed
[SOURce]:POWer:STARt
<value>
dBm
[SOURce]:POWer:STOP
<value>
dBm
[SOURce]:POWer:STEP?
dB
[SOURce]:POWer:ALC
ON|OFF|1|0
ON
[SOURce]:POWer:ALC:LOWN
ON|OFF|1|0
OFF
[SOURce]:POWer:ALC:HOLD
ON|OFF|1|0
OFF
[SOURce]:POWer:ATTenuation
<value>
dB
[SOURce]:POWer:ATTenuation:AUTO
ON|OFF|1|0
ON
[SOURce]:POWer:ATTenuation:LIST?
[:LEVel][:IMMediate][:AMPLitude]
[SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude] <value><unit>
[SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]?
This command sets the RF output power.
:MODE
[SOURce]:POWer:MODE CW|LIST|SWEep
[SOURce]:POWer:MODE?
This command sets the signal generator power mode to fixed or swept.
FIX
This choice stops a power sweep, allowing the signal generator to operate at
a fixed power level. Refer to
[:LEVel][:IMMediate][:AMPLitude]
command
for setting the output power level.
LIST or SWEep
This choice selects the swept power mode. If sweep triggering is set to
immediate along with continuous sweep mode, executing the command starts
the LIST or STEP power sweep.
:STARt
[SOURce]:POWer:STARt <value><unit>
[SOURce]:POWer:STARt?
This command sets the first amplitude point in a step sweep.
Range
:STOP