13 [source]:am subsystem (amplitude modulation), Sour, Ubsystem – BNC 835 Programmer Manual User Manual
Page 46: Mplitude, Odulation, Source]:am subsystem (amplitude modulation)
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.13
[SOURce]:AM Subsystem (Amplitude Modulation)
Command
Parameters
Unit (default)
[SOURce]:AM:DEPTh
<value>
0.8 (80 PCT)
[SOURce]:AM:STATe
ON|OFF|1|0
[SOURce]:AM:INTernal:FREQuency
<value>
400 Hz
[SOURce]:AM:SOURce
INTernal | EXTernal
:AM:DEPTh
[SOURce]:AM[:DEPTh]: <value>
[SOURce]:AM[:DEPTh]:?
This command sets the amplitude modulation depth 0...1.
*RST 0.8
Range 0-0.99
:AM:INT:FREQuency
[SOURce]:AM:INTernal:FREQuency <value><unit>|UP|DOWN
[SOURce]:AM:INTernal:FREQuency?
This command sets the internal amplitude modulation rate.
*RST 400 Hz
Range 10 Hz to 50’000 Hz
The RF carrier is modulated when you have set the signal generator’s AM modulation state to ON.
Whenever amplitude modulation is enabled, the AM on is in the display.