BNC 835 Programmer Manual - Manual (Page 55)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.18 [SOURce]:VOR Subsystem
This subsystem provides VOR signal generation. It is only available to devices featuring the avionics
modulations extension (AVIO).
Command Parameters Unit
(default)
[SOURce]:VOR[:STATe] ON|OFF|1|0 OFF
[SOURce]:VOR:BEARing <value> 0 rad
[SOURce]:VOR:TEST NORTh|SOUTh|EAST|WEST|1|2 NORTh
:VOR[:STATe]
[SOURce]:ILS:GS[:STATe] ON|OFF|1|0
[SOURce]:ILS:GS[:STATe]?
This command enables or disables the VOR modulation.
*RST OFF
:VOR[:STATe]
[SOURce]:VOR:BEARing <value> [RAD|DEG]
[SOURce]:VOR:BEARing?
This command sets the VOR bearing in radians. Append DEG to set the bearing in degrees.
*RST OFF
:VOR:TEST
[SOURce]:ILS:GS:TEST NORTh|SOUTh|EAST|WEST|1|2
This command selects a predefined VOR test setting.
*RST NORTh