BNC 835 Programmer Manual - Manual (Page 32)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.8 [SOURce]:CORRection Subsystem
Command Parameters Unit
(default)
Remark
[:SOURce]:CORRection:FLATness:MODE LOWer|HIGHer|INTerpolati
on
INT
[:SOURce]:CORRection:FLATness:PAIR <value>,<value> N/A
[:SOURce]:CORRection:FLATness:POINts? N/A
[:SOURce]:CORRection:FLATness:PRESet N/A
[:SOURce]:CORRection:FLATness[:STATe] ON|OFF|1|0 N/A
[:MEMory]:FILE:CORRection:FLATness:DATA <”file name”>,<data> N/A
[:MEMory]:FILE:CORRection:FLATness:LOAD <”file name”> N/A
[:MEMory]:FILE:CORRection:FLATness:STORe <”file name”> N/A
FLATness:MODE
[:SOURce]:CORRection:FLATness:MODE LOWer|HIGHer|INTerpolation
This command defines how the flatness correction value will be determined at frequency settings
below, between or above the store correction pairs. LOWer selects the pair at or below an output
frequency setting. HIGHer selects the pair at or above the output frequency setting. INTerpolation
selects linear interpolation between the two pairs closes to the output frequency setting
The query returns the currently selected mode.
*RST INT
:FLATness:PAIR
[:SOURce]:CORRection:FLATness:PAIR <freq.>[<freq suffix>], <corr.>[<corr suffix>]
[:SOURce]:CORRection:FLATness:PAIR? <point>
This command form adds or changes a frequency and amplitude correction pair. The maximum
number of points that can be entered is 3201.
The query form returns the frequency and amplitude correction pair at the given point index. The index
ranges from 0 to the number of points minus 1.
Range Frequency range varies and is model dependent. Please refer to the instrument’s
Data Sheet.
:FLATness:POINts
[:SOURce]:CORRection:FLATness:POINts?
This query returns the number of points in the user- flatness correction file.
:FLATness:PRESet
[:SOURce]:CORRection:FLATness:PRESet