BNC 835 Programmer Manual - Manual (Page 49)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.15 [SOURce]:PM Subsystem (Phase Modulation)
8
Command Parameters Unit (default)
[SOURce:]PM:DEViation <value> 2.4048 rad
[SOURce:]PM:SENSitivity <value> 2.4048 rad/V
[SOURce:]PM:INTernal:FREQuency <value> 400 Hz
[SOURce:]PM:INTernal:SHAPe RD|RU|SINE|SQUare|TRIangle SINE
[SOURce:]PM:SOURce EXTernal | INTernal EXT
[SOURce:]PM:STATe ON|OFF|1|0 OFF
:PM:DEViation
[SOURce]:PM:SENSitivity <value>
[SOURce]:PM: SENSitivity?
This command sets the phase modulation deviation. This setting will be used if :PM:SOURce is set to
LFGenerator.
The variable <value> is expressed in units of radians.
*RST 2.4048
:PM:SENSitivity
[SOURce]:FM:SENSitivity <value>
[SOURce]:FM: SENSitivity?
This command sets the phase modulation deviation per one volt peak amplitude signal input. This
setting will be used if :PM:SOURce is set to EXTernal.
The variable <value> is expressed in units of radians per Volt.
*RST 2.4048
:PM:INTernal:FREQuency
[SOURce]:PM:INTernal:FREQuency <value>
[SOURce]:PM:INTernal:FREQuency?
This command sets the phase modulation rate in Hz. This setting will be used if :PM:SOURce is set to
INTernal.
The variable <value> is expressed in Hertz.
*RST 400
:PM:INT:SHAPe
[SOURce]:PM:INT:SHAPe RD|RU|SINE|SQUare|TRIangle
[SOURce]:PM:INT:SHAPe?
This command specifies the PM modulation shape. RD selects Ramp-Down and RU ramp up.
Standard waveforms available are SINE, SQUare and TRIangle.