BNC 835 Programmer Manual - Manual (Page 35)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.9 [SOURce]:ROSCillator Subsystem
Command Parameters Unit
(default)
Remark
[SOURce]:ROSCillator:EXTernal:FREQuency <val> 10 MHz
[SOURce]:ROSCillator:LOCKed?
[SOURce]:ROSCillator:OUTPut:STATe ON|OFF|1|0 OFF
[SOURce]:ROSCillator:SOURce INTernal|
EXTernal|
SLAVe
INT
[SOURce]:ROSCillator:INTernal:TUNing <val> N/A
[SOURce]:ROSCillator:OUTPut:FREQuency <val> 10 MHz
: EXTernal:FREQuency
[SOURce]:ROSCillator:EXTernal:FREQuency <val>
[SOURce]:ROSCillator:EXTernal:FREQuency?
This command conveys the expected reference frequency value of an externally applied reference the
signal generator. The variable <val> is expressed in units of MHz.
*RST 10 MHz
Range 1 to 250 MHz
: LOCKed?
[SOURce]:ROSCillator:LOCKed?
This command queries if the synthesizer is locked to the externally applied reference.
:OUTPut:STATe
[SOURce]:ROSCillator:OUTPut:STATe ON|OFF|1|0
[SOURce]:ROSCillator:OUTPut:STATe?
This command enables or disables the 10 frequency reference output.
*RST OFF
: SOURce
[SOURce]:ROSCillator:SOURce INT|EXT|SLAVe
This command selects either an internal or external reference for the waveform clock. Slave mode
uses a 100 MHz external reference directly. Slave mode is intended to use another BENCHTOP
MICROWAVE SOURCE device’s reference (reference output setting 100 MHz).
*RST INT