Apple Logic Pro 9 - Manual (Page 385)

Nudging Regions with Key Commands
By predefining a nudge value, you can move selected regions according to this value.
Set the nudge value using the following key commands:
• Set Nudge Value to Tick
• Set Nudge Value to Division
• Set Nudge Value to Beat
• Set Nudge Value to Bar
• Set Nudge Value to SMPTE Frame
• Set Nudge Value to 0.5 SMPTE Frame
• Set Nudge Value to 5 SMPTE Frames
• Set Nudge Value to Sample
• Set Nudge Value to 1 ms
• Set Nudge Value to 10 ms
To nudge selected regions using a predefined value
µ
Hold down the Option key and press the Left or Right Arrow key.
You can also use the following key commands to nudge (move to the right or left) selected
regions by the corresponding grid amount:
• Nudge Region/Event Position Right by SMPTE Frame
• Nudge Region/Event Position Left by SMPTE Frame
• Nudge Region/Event Position Right by 1/2 SMPTE Frame
• Nudge Region/Event Position Left by 1/2 SMPTE Frame
• Nudge Region/Event Position Right by 5 SMPTE Frames
• Nudge Region/Event Position Left by 5 SMPTE Frames
• Nudge Region/Event Position Right by SMPTE Bit
• Nudge Region/Event Position Left by SMPTE Bit
• Nudge Region/Event Position Right by Tick
• Nudge Region/Event Position Left by Tick
• Nudge Region/Event Position Right by Division
• Nudge Region/Event Position Left by Division
• Nudge Region/Event Position Right by Beat
• Nudge Region/Event Position Left by Beat
• Nudge Region/Event Position Right by Bar
• Nudge Region/Event Position Left by Bar
385 Chapter 13 Creating Your Arrangement