JLG 800A_AJ ANSI Service Manual - Manual (Page 113)

SECTION 3 - CHASSIS & TURNTABLE
3120740 – JLG Lift – 3-57
6. While keeping Thrust Washers in place, slide Cluster
Gear into Carrier with the larger gear on the side
with the small pin hole.
7. Line up Cluster Gear and thrust Washers with hole in
Carrier and slide Planet Shaft through. Line up
chamfered side of hole in Planet Shaft with pin hole
in Carrier.
8. Drive Anti-Roll Pin flush into Carrier hole, thereby
locking Planet Shaft into place.
9. Repeat these steps for remaining two Cluster Gears
to complete Carrier Sub Assembly.