JLG 800A_AJ ANSI Service Manual - Manual (Page 193)

SECTION 3 - CHASSIS & TURNTABLE
3120740 – JLG Lift – 3-137
Propane Fuel Filter Replacement
REMOVAL
1. Relieve the propane fuel system pressure. Refer to
Propane Fuel System Pressure Relief.
2. Disconnect the negative battery cable.
3. Slowly loosen the Filter housing and remove it.
4. Pull the filter housing from the Electric lock off
assembly.
5. Remove the filter from the housing.
6. Locate Filter magnet and remove it.
7. Remove and discard the housing seal.
8. If equipped, remove and discard the retaining bolt
seal.
9. Remove and discard mounting plate to lock off O-
ring seal.
INSTALLATION
BE SURE TO REINSTALL THE FILTER MAGNET INTO THE HOUS-
ING BEFORE INSTALLING NEW SEAL
1. Install the mounting plate to lock off O-ring seal.
2. If equipped, install the retaining bolt seal.
3. Install the housing seal.
4. Drop the magnet into the bottom of the filter hous-
ing.
5. Install the filter into the housing.
6. If equipped, install the retaining bolt into the filter
housing.
7. Install the filter up to the bottom of the electric lock
off.
8. Tighten the filter bowl retainer to 106 in lbs (12 Nm).
9. Open manual shut-off valve. Start the vehicle and
leak check the propane fuel system at each serviced
fitting. Refer to Propane Fuel System Leak Test.
1 1
2 13
3 3
4 4
5 5
6
7 7
8 8
9 9
OR
10 10
11
11
12
1. Electric Lock Off Solenoid
2. Mounting Plate
3. Housing Seal
4. Filter Magnet
5. Filter Housing
6. Seal 7. Electrical Connector
8. Fuel Outlet
9. O-ring
10. Filter
11. Fuel Inlet
12. Retaining Bolt
Figure 3-81. Filter Lock Assembly