JLG 800A_AJ ANSI Service Manual User Manual
Page 248
Advertising
SECTION 4 - BOOM & PLATFORM
4-34
– JLG Lift –
3120740
16. To remove the main pressure seals (205), it is easi-
est to cut them using a sharp razor blade being
careful not to damage the seal groove.
17. Remove the thrust washers (304), from the end cap
(4) and shaft (2).
18. Remove the wiper seal (304.1) from its groove
in the
end cap (4) and shaft (2).
19. Remove the piston O.D. seal (202).
20. Remove the piston I.D. seal (200). You may now pro-
ceed to the inspection process.
Advertising