JLG 800A_AJ ANSI Service Manual User Manual
Page 243
SECTION 4 - BOOM & PLATFORM
3120740
– JLG Lift –
4-29
The seal tool is merely a customized standard flat head
screwdriver. To make this tool you will need to heat the flat
end with a torch. Secure the heated end of the screwdriver
in a vice and physically bend the heated end to a slight
radius. Once the radius is achieved round off all sharp
edges of the heated end by using a grinder. There may be
some slight modifications for your own personal prefer-
ence.
PARTS
1. Housing
2. Shaft
3. Piston Sleeve
4. End Cap
HARDWARE
103.1. Screw
103.2 . Washer
106.1. Port Plug
106.2. Port Plug
109 . Lock Pin
113. Capscrew
SEALS
200. T-Seal
202. T-Seal
204. O-ring
205. Cup Seal
207. Backup Ring
304.1. Wiper Seal
BEARINGS
302. Wear Guide
304. Thrust Washer
ACCESSORIES
400. Stop Tube
420.1 Bushing
420.2 Bushing
421.1 Bushing
Figure 4-19. Rotator - Exploded View (S/N 0300067538 to Present)