2N Analogue UMTS gateway 2N EasyGate UMTS USB - User Manual, v1.00 - Manual (Page 14)

13
5.3. Automatic Call ("Baby Call")
If the Baby Call function is enabled, a pre-programmed period of time is counted
down after off-hook. If you do not start dialing within this timeout, EasyGate UMTS Data
signals dialing end and starts establishing a call to the pre-programmed number
automatically – from now on EasyGate UMTS Data behaves as if a standard outgoing
call had been established. Any dialing during the Baby Call timeout cancels this function
and a standard outgoing call can be made.
5.4. Tariff pulses 16 or 12 kHz
EasyGate UMTS Data has tariff pulse transmitter. You can use tariff pulses for
outgoing call pricing. EasyGate UMTS Data offer pseudo tariff only – tariff metering
doesn’t correspond to real price of call, tariff pulses are transmitted according to
programmed parameters and call duration. You must program specific parameters in
call table to set tariff metering for different prefixes of dialed numbers.
You can also program EasyGate UMTS Data to transmit tariff pulses as call
connect/disconnect signaling if your PBX cannot receive telephone line polarity change
signaling.
5.5. Configuration of network services
EasyGate provides some of network services to improve possibility of usage. The
configuration is done by standard Star-Hash codes you can know from mobile phones.
To configure these services:
1. Hook off the telephone, you can hear the dial tone.
2. Enter the Star-Hash code described below.
3. Wait for information tone. You may wait about 3 seconds.
4. Hook on.
Information tones:
Confirmation - OK:
•
Confirms that the service was configured correctly.
Confirmation - bad:
•
Service was not correctly configured
•
Service isn’t activated by your provider
Confirmation - service activated:
•
Confirms that the service was configured correctly and the service is activated.
Confirmation - service deactivated:
•
Confirms that the service was configured correctly and the service is deactivated.