2N Analogue UMTS gateway 2N EasyGate UMTS USB - User Manual, v1.00 User Manual
Page 22
21
7. Save data into EasyGate UMTS Data – if EasyGate UMTS Data is not in its special
programming mode, you are invited to switch EasyGate UMTS Data off and on
again.
8.2.2. Further Data Handling Options
In addition to the EasyGate UMTS Data memory, settings can be saved in a PC file
and reloaded into the PCManager. This is recommended for backing up of current
configurations or saving the same configuration in another EasyGate UMTS Data unit.
Caution! The table Security includes the PIN code and service password. These
parameters have a special handling. They are not saved in a PC file for security
reasons. If you load a PC file into the PCManager and then into EasyGate UMTS Data,
the PIN and service password should not change unless you change them manually
before saving.
Caution! All tables are filled-in with default values after PCManager start. It is
recommended to load data from EasyGate UMTS Data before parameters programming
and saving. If you only save data after PCManager start, all parameters except the PIN
and service password in the EasyGate UMTS Data memory will have default values.
Caution! The PIN and service password can only be modified either manually or by
full initialization.
8.2.3. Upgrade
The manufacturer responds to clients' requirements with periodical firmware
updating. The current EasyGate UMTS Data firmware, PCManager and User Manual
are available
. The latest firmware version is always included in every new
PCManager installation.
Upgrading procedure:
1. Run the PCManager, select the language for displaying texts on the right-hand side.
2. Click on the CD-ROM icon for data handling on the left-hand side.
3. Click on the upgrade – if EasyGate UMTS Data is not in its special programming
mode, you are invited to switch EasyGate UMTS Data off and on again.
4. The upgrade takes place automatically. Do not switch your PC or EasyGate
UMTS Data off during the process of upgrading!
Caution! The PCManager checks the software version in EasyGate UMTS Data and
the upgrade file. If the version in the file is new, everything is all right. An identical or
earlier software version is stored in EasyGate UMTS Data too but the PCManager
requires confirmation to be on the safe side.
8.2.4. Monitoring
This function is not supported by EasyGate UMTS Data.
8.2.5. Other control buttons
In the bottom of PC Manager window there can be found buttons for closing the
application, minimizing into the tray and showing information about application. You can
change the COM port for communication with EasyGate with button Setup. The chosen
port must be the same with which is EasyGate UMTS Data connected to PC. The
settings Hardware version must agreed with Your EasyGate UMTS Data. The EasyGate