Easygate umts data parameter programming – 2N Analogue UMTS gateway 2N EasyGate UMTS USB - User Manual, v1.00 User Manual
Page 20
19
8. EasyGate UMTS Data Parameter Programming
All EasyGate UMTS Data parameters have such default values that meet most users’
demands and need not be changed. To change EasyGate UMTS Data parameters in
spite of that, you can either:
•
Use a PC with the PCManager installed. All functions supported by EasyGate
UMTS Data can be set using the PC.
•
Or use the DTMF programming on a telephone line. Not all functions can be set in
this way.
8.1. Telephone Line based Programming
1. Hook off the telephone, you can hear the dial tone or the busy tone, and the Line
LED starts flashing.
2. Enter the service password (12345 by default, can be changed) with the DTMF; to
cancel a wrong password hang up before sending the
character.
3. To confirm password enter a
.
4. If you have entered a correct password, you hear the confirmation tone. If not, the
dialed number may be sent to the network as a call. To prevent this, hang up when
you do not hear the confirmation tone.
5. EasyGate UMTS Data shall remain in the programming mode until hang-up.
6. Enter the number of the parameter to be programmed and press a
. If the
parameter number is correct, you can hear the confirmation tone, if not, you get the
refusal tone and can re-enter the parameter number.
7. When the parameter number is confirmed, enter the allowed parameter value and
press a
. If the parameter value is in the allowed range, you can hear the saving
tone, if not, you get the refusal tone. You can enter another parameter number in
either case.
Numeric parameters are programmed using numbers in units included in the
parameter description. For YES/NO parameters use
for YES and
for NO.
To cancel any programming step in the programming mode, press a
. Having
done so, you can hear the refusal tone and can enter a new parameter number.
Parameters are saved when the saving tone is transmitted. Hang up to quit
programming.
Example:
Password entering, OK
Transmission volume parameter, OK
Set to medium level, saved
Non-existent parameter number, refusal