2N Analogue UMTS gateway 2N EasyGate UMTS USB - User Manual, v1.00 - Manual (Page 28)

27
8.3.2. FXS routing parameters
All parameters related to the number dialed for an outgoing call are arranged in this
table. According to the prefix you can:
•
Bar the number to be dialed - the calling subscriber hears the busy tone;
•
Accelerate connection establishing by knowing the number length for the given
prefix;
•
Accelerate connection establishing by allowing to terminate dialing with a #;
•
Modify the number to be dialed by removing and/or adding digits.
•
Set tariff metering for the given prefix.
Every table line includes a prefix (of variable length) plus parameters that define
EasyGate UMTS Data's behavior in case the beginning of the dialed number matches
this prefix. The table can contain up to 20 different prefixes.
There may be exceptions to the rule - a number may start with the same digits but
has to be served in a different way. Any table line that starts with the same prefix
followed by one or more digits is considered an exception of the line with shorter prefix.
Remember to complete the "Other numbers" line for a number whose prefix is not
included in the table.
An example in the figure below shows how to bar all international calls with the
exception of calls to Slovakia including dialing acceleration by selecting the number
length parameter and tariff setting (5 impulses after call connect and then one impulse
every 10 seconds). All other calls are enabled and their tariff is one impulse every 30
second.