2N Helios IP User manual, 1510 v1.13 - Manual (Page 60)

Configuration 3.3
60
3.3 Configuration
2N ® Helios IP is configured through an integrated administration web server. Connect
2N ® Helios IP to the IP network and make sure that 2N ® Helios IP is powered.
IP Address Obtaining from DHCP
By default, obtaining the IP address from the DHCP server is selected in 2N ® Helios IP.
After power up, 2N ® Helios IP automatically receives the IP address from the DHCP
server. If you do not have access to the DHCP server, you can find the IP address
received with the HeliosIPNetScanner program, which is available on the installation
CD. If 2N
® Helios IP is switched to the static IP address mode, switch it to the DHCP IP
address obtaining mode as follows:
1. Power on 2N ® Helios IP.
2. Wait until 2N ® Helios IP completes the booting process. The end is signalled
by a sequence of tones .
3. Within 30 seconds push the buttons as described in the Switching to Default
Network Parameters – Dynamic IP Address subsection.
4. Switching to the DHCP IP address obtaining mode is signalled by a sequence
of tones .
5. Wait until the device is restarted.
Manual IP Address Setting
If the DHCP server is unavailable, you can set a default static IP address in your
2N
® Helios IP. Proceed as follows:
1. Power on 2N ® Helios IP.
2. Wait until 2N ® Helios IP completes the booting process. The end is signalled
by a sequence of tones
.
3. Within 30 seconds push the buttons as described in the Switching to Default
Network Parameters – Static IP Address subsection.
4. Switching to the default static IP address mode is signalled by a sequence of
tones
.
5. Wait until the device is restarted.
6. Now, 2N ® Helios IP has the following network parameters:
IP address: 192.168.1.100
Network mask: 255.255.255.0
Default gateway: 192.168.1.1