2N EasyGate - User Manual - Manual (Page 14)

9
5. Voice function
Outgoing and incoming call establishing procedures for an analog telephone are
described for illustration. The procedures are the same for the EasyGate-PBX
connection, just remember to program call routing to EasyGate properly. Check
EasyGate’s function by connecting a telephone before.
Suppose that a SIM card has been inserted, the PIN code entered or not required,
the antenna connected and EasyGate registered to GSM network – the GSM network
LED is permanently on and you can hear the dial tone upon off-hook.
5.1. Outgoing Call
1. Hook off the telephone, you can hear the dial tone and the Line LED starts flashing.
2. Dial the required GSM subscriber number. Since EasyGate receives tone dialing by
default, select the DTMF mode. If your telephone transmits pulse dialing only,
program EasyGate to receive pulse dialing. The delay between digits to be dialed
may not exceed 5 s (programmable parameter). The number is evaluated as complete
and transmitted to the GSM network after this timeout.
3. A short delay follows the last-dialed digit for EasyGate to await further dialing. Then,
the dialing end is signaled and connection is established.
4. If the called subscriber is available, you can hear the ringing tone. If not, you can
hear the busy tone or any of the GSM provider’s messages.
5. When the called subscriber answers the call, a call is established. The Line LED is
permanently on during the call.
6. Hang up to terminate the call. The Line LED goes off. If the called subscriber is the
first to hang up, you can hear the busy tone and hang up.
5.2. Incoming Call
1. Ringing signals an incoming call. The Line LED flashes during ringing. If
programmed so, EasyGate transmits the CLIP by FSK between the first and second
rings. Advanced telephone sets are able to display the CLI.
2. Hook off the phone to establish the call. The Line LED is permanently on during the
call.
3. Hang up to terminate the call. The Line LED goes off. If the called subscriber is the
first to hang up, you can hear the busy tone and hang up.