2N EasyGate - User Manual - Manual (Page 25)

20
Beep after dialing end Function No.: -
Select a beep to signal the end of dialing (beginning of outgoing call
establishing).
Setting options: YES/NO
Default setting: YES
BabyCall number
Function No.: -
A number to be dialed for the automatic call function. If this item is blank, the
function is disabled.
Setting options: 0-15 characters (0-9,*,#,+)
Default setting: blank
BabyCall timeout [s]
Function No.: -
Time between line Off-Hook and automatic call beginning (if enabled). During this
timeout EasyGate waits for dialing that cancels the automatic call. You can make
standard call if the BabyCall function is enabled.
Setting options: 0-15 s
Setting step:
1 s
Default setting: 0 s
Transmission volume
Function No.: 10
Volume setting for GSM transmission with a 4 dB step.
Setting options: 1-5
Setting step:
1
Default setting: 3 = medium volume level
Reception volume
Function No.: 11
Volume setting for GSM reception with a 4 dB step.
Setting options: 1-5
Setting step:
1
Default setting: 3 = medium volume level
CLIP
Function No.: 19
Set this item to enable/disable identification of a telephone line calling from a
GSM network. The function can be enabled if you have a device on your
telephone line that is capable of receiving FSK according to ETSI standards.
Setting options:
Disable -EasyGate does not transmit the CLI.
FSK during ringing -EasyGate transmits the FSK-based CLI according to the
ETSI EN 300 659 standard (transmission during ringing).
Tbd. - prepared for future use
Default setting: Do not transmit.
Replace character + in CLI by
Function No.: -
If this parameter is filled, the + character in the international prefix of CLI is
replaced by the defined string. The + character can neither be transmitted by the
FSK protocol nor dialed by the DTMF from a terminal.
Setting options: 0-15 characters (0-9,*,#)
Default setting: blank